I have a 2000 Mitsubishi glant

Tiny
ANONYMOUS
  • MEMBER
  • 2000 MITSUBISHI GALANT
  • 100,000 MILES
I have a 2000 mitsubishi glant. Well to start off it died on my would not start come to find out it was the crank shaft sensor we replaced it and it run for a day or two. I parked it went to start it up would not start. I was told it was the fuel pump because when you turn on the key the pump would not come on until you cranked the motor so I replaced it and still the same I put a new fuel relay in it and a new cam shaft sensor and still no luck. I was told to take off the breather from the throttle body and squart some gas and try that I did put it just shot smoke and gas back at me so I toke my hand and put over the throttle body had my wife crank the car it would suck my hand in and then blow it off the throtttle body. Can you help me.
Sunday, October 21st, 2012 AT 6:11 AM

4 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Is the Malfunctioning Indicator Light showing and did you check for trouble codes?
Which engine do you have?
Was this
answer
helpful?
Yes
No
Sunday, October 21st, 2012 AT 6:14 AM
Tiny
AMBERSEXTON-MEEKS
  • MEMBER
  • 2 POSTS
3.4 liter and how do you get codes when it wont start
Was this
answer
helpful?
Yes
No
Sunday, October 21st, 2012 AT 6:19 AM
Tiny
AMBERSEXTON-MEEKS
  • MEMBER
  • 2 POSTS
Im sorry its a 2.4
Was this
answer
helpful?
Yes
No
Sunday, October 21st, 2012 AT 6:21 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Engine need not be started to retrieve trouble codes. A scan tool or code reader would power up when ignition switch is turned on.
Was this
answer
helpful?
Yes
No
Sunday, October 21st, 2012 AT 7:09 AM

Please login or register to post a reply.

Sponsored links