Power Steering Troubleshooting

2000 MERCURY SABLE
160,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
HAWKINS63
  • MEMBER
  • 1 POST
2000 Mercury Sable w/3.0...Wife says is noisy. Had to add a little steering fluid but fluid was dirty and foamy (had car serviced not too long ago). Started car, run a left to right check to listen to noise and upon turning car off...power steering fluid was blowing out the top of pump. Whats going on ?
Feb 9, 2011 at 7:29 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 34,308 POSTS
Very common Ford problem. There is trapped air in the system. It compresses when the engine is running, but it expands when the engine stops. That expansion pushes the fluid out. One tool that has been developed specifically for Fords is a vacuum pump that is supposed to expand the air bubble some more to help it come out.

caradiodoc
Feb 9, 2011 at 9:06 PM
Advertisement
Avatar
FIXITMR
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 9,990 POSTS
sounds like air in fluid. you will have to wait till fluid calms down and add it slowly. how was the noise? fords are KNOWN for being noisy, even new!
Feb 9, 2011 at 10:03 PM