How do you remove & install a starter on a 2000 Mazda 626 4cyl 16 valve DOHC?
Nov 23, 2010 at 9:04 PM
Starter removal
2000 MAZDA 626
DEVAJONES
- MEMBER
- 1 POST
- FOLLOW
Advertisement
1. Remove the battery.
2. Remove the air cleaner component.
3. Remove the transverse member.
4. Remove the intake manifold bracket. (FS)
5. Remove the fuel filter with the fuel hose still connected. Position the fuel filter so that it is out of the way. (KL ATX)
6. Remove the oil pipe. (KL ATX)
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
Starter Installation Note (FS)
FS/2.0L
* Tighten the starter fitting bolts in the following order:
Top
Center
Bottom
2. Remove the air cleaner component.
3. Remove the transverse member.
4. Remove the intake manifold bracket. (FS)
5. Remove the fuel filter with the fuel hose still connected. Position the fuel filter so that it is out of the way. (KL ATX)
6. Remove the oil pipe. (KL ATX)
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
Starter Installation Note (FS)
FS/2.0L
* Tighten the starter fitting bolts in the following order:
Top
Center
Bottom
Nov 23, 2010 at 10:01 PM