Jeep

2000 JEEP WRANGLER
105,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
TCBIRDWELL42
  • MEMBER
  • 1 POST
I have a 2000 jeep wrangler. Yesterday the engine would turn over but not start. Someone told me to change the crank sensor. I did so and it ran great. I drove it that night and this morning. When heading home it starts spuddering and back fires and dies. When i crank it back it spudders really bad and when i put it in drive it dies. Help?
Dec 24, 2010 at 1:31 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Recheck the crank sensor to make sure nothing came loose. Check fuel pump pressure also. Go to our home page under DIY for directions. Also, make sure the catalytic converter isn't plugging.
Jan 17, 2011 at 1:44 AM
Advertisement