Crankshaft Position Sensor

2000 JEEP GRAND CHEROKEE LAREDO
100,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MCAVINEE
  • MEMBER
  • 69 POSTS
I asked earlier abolut a no start on a Jeep Cherrokee 2003. I found another guy that had a Jeep in the grocery store parking lot and I talked to him and he said it was my crankshaft position sensor. Do you have a diagram on how to replace this?
Aug 8, 2011 at 5:27 PM
Advertisement
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Should be on left side of transmission bell-housing, remove bolt/s to remove sensor.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Aug 8, 2011 at 5:43 PM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
I looked at a 2000 instead of 2003.

With the 4.0L on trans bell housing. With 4.7L, it is above the starter.
Aug 8, 2011 at 5:51 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.