Crankshaft Position Sensor

2000 JEEP GRAND CHEROKEE LAREDO
100,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MCAVINEE
  • MEMBER
  • 69 POSTS
I asked earlier abolut a no start on a Jeep Cherrokee 2003. I found another guy that had a Jeep in the grocery store parking lot and I talked to him and he said it was my crankshaft position sensor. Do you have a diagram on how to replace this?
Aug 9, 2011 at 12:27 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,098 POSTS
Should be on left side of transmission bell-housing, remove bolt/s to remove sensor.
Image (Click to enlarge)
Attached Media
Aug 9, 2011 at 12:43 AM
Advertisement
Avatar
JDL
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,098 POSTS
I looked at a 2000 instead of 2003.

With the 4.0L on trans bell housing. With 4.7L, it is above the starter.
Aug 9, 2011 at 12:51 AM