how to put throwout bearing and fork back together afer replacing clutch on 2000 tiburon 4 cyl
Sep 29, 2012 at 2:24 PM
2000 tiburon
PERRYFREY
- MEMBER
- 6 POSTS
Advertisement
the throwout bearing just goes into the ears on the fork.
did you remove the fork??
Roy
did you remove the fork??
Roy
Sep 29, 2012 at 2:32 PM
yes replaced clutch now throw out and fork not going together right
Sep 29, 2012 at 2:34 PM
when i push the clutch pedal the slave pushes all the way out
Sep 29, 2012 at 2:42 PM
did you snap in the throwout bearing into the pressure plate??
Roy
Roy
Sep 29, 2012 at 2:49 PM
does the throwout bearing need to snap into snap on fingers ?
Sep 29, 2012 at 2:50 PM
i put throwout on fork and not pressure plate
Sep 29, 2012 at 2:54 PM
not the fingers, the pressure plate.
if the slave is fully extended, it may have already seated. can you shift into gear with it running??
did you adjust the rod on the clutch master??
Roy
if the slave is fully extended, it may have already seated. can you shift into gear with it running??
did you adjust the rod on the clutch master??
Roy
Sep 29, 2012 at 2:55 PM
no how do you do that?
Sep 29, 2012 at 3:09 PM
under the dash at the clutch pedal. you need a 12mm open end wrench to loosen the nut and turn the rod.
Roy
Roy
Sep 29, 2012 at 4:22 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.