2000 Hyundai Accent. OBDII Codes 1402 & 1403

2000 HYUNDAI ACCENT
169,000 MILES • 4 CYL • FWD • MANUAL
Avatar
NEIL.WARRINGTON
  • MEMBER
  • 1 POST
2000 Hyundai Accent. I'm getting obdII codes of 1402 and 1403. As well as a misfire code. The car runs, but lacks acceleration and runs rough, it also is having lots of difficulty starting in the cold weather (-5 and below). I believe its a DMTL motor/valve code, but is there any way to be sure before I go replace it.

thanks,

Neil
Mar 7, 2011 at 5:34 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
Diagnostic Module Tank Leakage

Lagging acceleration could be caused by the following below:

Oxygen sensors.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Manifold absolute pressure sensor.
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.

Note:If it doesn't apply disregard.

Mar 7, 2011 at 5:53 AM
Advertisement