2000 Honda CRV brake light switch

2000 HONDA CRV
40,000 MILES
Avatar
PENUCH52
  • MEMBER
  • 1 POST
I need to replace a brake light switch after the rats got to the wiring. Does the trim style, LX or EX have any bearing on this switch replacement; also, what about 2 and 4 wheel drive, does this make any difference in buying a replacement unit for my vehicle?
Oct 11, 2013 at 6:39 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
it shouldn't
Stoplight switch is located under dash, above brake pedal. To adjust, loosen lock nuts and turn switch until plunger is fully depressed (threaded end touching pedal arm pad).
Back off switch 1/4 turn (3/4 turn on Prelude, Odyssey and Accord), and tighten lock nuts. Clearance between threaded end of switch body and brake pedal switch contact pad should be about .010" (.30 mm) on all models except Prelude and Accord. On Prelude and Accord, clearance should be .035" (.90 mm). On all models, ensure brakelights go off when pedal is released. See Fig. 8. Tighten lock nut firmly and connect brake switch connector. See TORQUE SPECIFICATIONS.
Image (Click to enlarge)
Attached Media
Oct 11, 2013 at 9:27 AM
Advertisement