Intake manifold runner control

2000 FORD WINDSTAR
116,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
M-STAR
  • MEMBER
  • 1 POST
These are IMRC questions. From visual inspection I noticed the connector rods were unconnected. The back one was missing. (1) How is the IMRC actuator attached ( for removal purpose )? (2) Can the rods be reconnected ( via original or alternative method )? Reclaimed parts will be considered. There are no noticeable effects in normal driving. CEL illuminates, instead of oxygen sensor issues, maybe IMRC is the culprit. THANKS
Feb 10, 2011 at 5:13 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
I would say the IMRC would for sure set a code if it's not connected. The rod snaps into a plastic clip that may or may not be re-used. They are very inexpensive from Ford. Even the rod isn't much. I just bought one for under $20
Feb 10, 2011 at 5:32 PM
Advertisement