2000 Ford Windstar front lights wont comw on

Tiny
TOMMYBOY65
  • MEMBER
  • 2000 FORD WINDSTAR
  • AUTOMATIC
  • 177,000 MILES
My front directionals, hazzards, and high and low beams wont come on. I check all rralted fuses. The rear hazzards and directionals work ok. The hazards and the directionals blink real fast in the dash
Wednesday, January 15th, 2014 AT 7:53 PM

3 Replies

Tiny
TY ANDERSON
  • MECHANIC
  • 719 POSTS
The front electronic control module controls the headlights and the front signal lights/ park lamps. There is a rear electronic control module that control the rear taillights. So I think you have an issues with the front electronic control module. Whether your not getting power or grounds to the module or the fuses or relays are not supplying power. The front control module is located under the dash board on the driver side.
If you have access to a ford compatible scan tool you could try communicating with front electronic module to check for any fault codes.
This system uses a lot of fuses so make sure you checking them all inside the vehicle and under the hood.
Was this
answer
helpful?
Yes
No
Wednesday, January 15th, 2014 AT 8:26 PM
Tiny
TOMMYBOY65
  • MEMBER
  • 2 POSTS
Thank u man. Im sorry I don't havw a credit card. Is there a way to check the module?
Was this
answer
helpful?
Yes
No
-1
Wednesday, January 15th, 2014 AT 8:48 PM
Tiny
TY ANDERSON
  • MECHANIC
  • 719 POSTS
The only way I know of is with a compatible ford scan tool to access the module and for diagnostic fault codes stored. I believe this module will require programming if replaced.
Was this
answer
helpful?
Yes
No
Thursday, January 16th, 2014 AT 7:56 PM

Please login or register to post a reply.

Sponsored links