It just seems that there are no good paces to place the stands. Stands have the open u tops on them.
Nov 25, 2011 at 3:40 AM
Where should jack stands be placed , both front and rear?
2000 FORD TAURUS
MRPECK129
- MEMBER
- 6 POSTS
Advertisement
FIXITMR
- ✓ASE Certified Mechanic
- 9,990 POSTS
open u? can you post pic?
Nov 25, 2011 at 3:51 AM
stand pic
Image (Click to enlarge)
Nov 25, 2011 at 8:40 PM
MHPAUTOS
- ✓ASE Certified Mechanic
- 31,937 POSTS
Depending on what you need to work on? they will work fine under the lower control arms, when the weight comes down the suspension will settle and they will be firm. body pinch welds, at rear on suspension arms or body pinch welds, get the weight on the stands and give a little shake just to make sure it has settled, work on firm flat concrete floor as well, if in doubt get someone with more experience to check first hand as to the positioning of the stands.
Heres a guide on that subject, it will help
https://www.2carpros.com/articles/jack-up-and-lift-your-car-safely
And a video
https://youtu.be/xLFn_bMkZc0
Heres a guide on that subject, it will help
https://www.2carpros.com/articles/jack-up-and-lift-your-car-safely
And a video
https://youtu.be/xLFn_bMkZc0
Nov 26, 2011 at 1:11 AM
I need to know where to put jack stands in order to replace the rear drum brakes on my 2006 Ford Taurus SE?
Jan 26, 2019 at 8:50 PM
(Merged)
JACOBANDNICKOLAS
- ✓ASE Certified Mechanic
- 110,194 POSTS
If you follow the pinch weld along the bottom of the vehicle, in front of the rear tires you will see a place for a jack. That is where I recommend.
Jan 26, 2019 at 8:50 PM
(Merged)
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.