Ford Explorer help

Tiny
CAROLYNN LAPRE
  • MEMBER
  • 2000 FORD EXPLORER
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 250,000 MILES
We are rebuilding my 2000 Ford Explorer and have a wire hooked into the wiring harness with a clip. The other end of the wire has a round circle sensor looking end. I need to know where the circle end goes.
Sunday, December 19th, 2010 AT 12:42 AM

6 Replies

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
This is a bit hard to visualize, can you post a pic? If the sensor is attached with a bolt through the middle it may be a knock sensor.

Mark (mhpautos)
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 1:06 AM
Tiny
CAROLYNN LAPRE
  • MEMBER
  • 4 POSTS
It may be attached with a bolt, I will try to send the picture again. Where does the knock sensor bolt into?
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 1:14 AM
Tiny
CAROLYNN LAPRE
  • MEMBER
  • 4 POSTS
I did not get the answer to my question of where does the sensor end of this knock sensor go an a 2000 ford explorer. Can you help?
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 9:16 PM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
I did send, but the new system is having a few problems, anyway, according to Mitchell 1 data base, it is located under the inlet manifold, they do not supply a pic, but it will bolt directly onto the block, I am looking for a location pic elsewhere.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 10:04 PM
Tiny
CAROLYNN LAPRE
  • MEMBER
  • 4 POSTS
Thank you soooo much. We will continue to try to find the location. If you are able to find a picture, I would greatly appreciate it. My wish for Christmas that my car will be back together and running by then seems to be closer to reality now. Thank you!
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 10:12 PM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
You may not hear from me for a bit as I am in Australia and I got to head off to work now, it's 9-30 AM Monday here, so I will be back on after my shift this evening.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Sunday, December 19th, 2010 AT 10:24 PM

Please login or register to post a reply.

Related General Content

GUIDE
Inquire Here

Sponsored links