vibrating sound

100,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
RHOLANDO
  • MEMBER
  • 17 POSTS
i hear some rumbling or vibrating sound when i turn on ignition switch it usually last about 10 to 15 second and i can feel it coming from the right front portion of my ford expedition 2000 is it normal? or does it need some checking?
Aug 9, 2011 at 11:36 PM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
Pop the hood and try to find the source of the noise before it quits. You might also consider having a mechanic listen to it. If you have anti-lock brakes, you might be hearing the pump replenish any pressurized brake fluid that may have leaked down. There might also be a pump for an automatic load-leveling system that's running.

On many vehicles the load-leveling pump won't run if a door is open so you might try leaving your door open to see if the noise is still heard. On some anti-lock brake systems the power brake assist comes from the pressurized brake fluid. Pumping the brake pedal a dozen times will deplete the pressure and the pump will turn on again and run for about ten seconds to build the pressure back up.
Aug 10, 2011 at 1:38 AM
Avatar
RHOLANDO
  • MEMBER
  • 17 POSTS
Hi caradiodoc it seems to be the automatic load-leveling, as soon as i hear the rumbling sound i immediately open the door and it surely stopped then the sound resume when i close the door, it does finish its leveling, so i guess its a normal sound? is frequent leveling normal?
Aug 11, 2011 at 9:02 PM
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
It is common for the system to do its thing each time you start the engine, but they do cause a real lot of headaches for people. The system will run also to raise the back end in response to how ever many dead bodies you have in there. When it starts to run repeatedly, one of the air springs or plastic hose going to it has a leak. Those can be fixed but it can take a while to find some leaks.

When the pump fails, and it will, you'll be in for a shock at the cost of repair, assuming the parts are still available. Most people elect to remove the system and install regular coil springs.
Aug 11, 2011 at 11:20 PM
Avatar
RHOLANDO
  • MEMBER
  • 17 POSTS
I see, but when it fails will there be other parts damage with it will i still have an option to remove it and replace it with a regular coil spring?
Aug 14, 2011 at 6:59 PM
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
Usually the pump motor dies or one of the air springs pops a leak, then the rear of the car sits too low. No other damage normally occurs.
Aug 14, 2011 at 10:30 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement