installing timming belt

2000 FORD CONTOUR
125,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
GRWRIGHTSR
  • MEMBER
  • 1 POST
2000 contour 2.2 instruction how to install timming belt
Feb 5, 2011 at 11:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
The procedure for this vehicle is very involved and requires special tools to get it timed correctly. Many experienced techs have messed up on this one. I don't advise you trying this one and if you are determined, purchase a service manual first and don't attempt it without the tools required.
Feb 6, 2011 at 12:03 AM
Advertisement
Avatar
BMRFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 19,053 POSTS
Its not a drive way job

Special Tool(s)Needed
1- Timing Tool, Camshaft Alignment
303-465 (T94P-6256-CH)

2- Timing Peg, Crankshaft Position
303-574 (T97P-6000-A)

3- Cam Sprocket Holding/Removing Tool
303-098 (T74P-6256-B)
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Feb 6, 2011 at 2:32 AM