Help me please

Tiny
CADAMS72206
  • MEMBER
  • 2000 FORD CONTOUR
  • 152,000 MILES
Help! I have replaced the Pcv IAC tps Pcv hose cleaned the maf plugs wires tested fuel pressure all fluids are full and have checked all vacuum lines no iss ues or I replaced them and the car isles rough with a/c on and will stall when on full blast and sometimes it will work ok till u tap the gas th started the rough isles and wants to shut on and it acts like its missing bad if u hold the pedal down it will rev but spits and sputters can u help m en it e find out what's wrong I have no engine lights on and have run a fuel pressure test and seems fine and scanner tool says it all ok I think its a 2000 Ford contour with the 2.0 and a non returnless fuel system
Monday, March 19th, 2012 AT 11:14 PM

9 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Scan the computer for code/s if any post them
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:03 AM
Tiny
CADAMS72206
  • MEMBER
  • 16 POSTS
There are not I already have tried that I have a scanner
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:16 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the alternator if its putting out the correct voltages, recheck the IACV and check the EGR and PCV valves-to include the throttle position sensor
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:35 AM
Tiny
CADAMS72206
  • MEMBER
  • 16 POSTS
I have rebuimt the alternator and have replace the TPS AND IAC
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:37 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Go to this link:https://www.2carpros.com/articles/engine-misfires-or-runs-rough
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:39 AM
Tiny
CADAMS72206
  • MEMBER
  • 16 POSTS
I DID AND I'M GETTING NO WHERE EACH PLUG HAS SPARK SORRY FOR THE UPPERCASE
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 12:42 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the valve and ignition timing-also verify fuel pressure if its within specs-
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 1:26 AM
Tiny
CADAMS72206
  • MEMBER
  • 16 POSTS
I'm getting 30 psi continuos when I hit the throttle it goes up to 45 timing is 11 degrees at idle how do I check valve timming
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 1:32 AM
Tiny
CADIEMAN
  • MECHANIC
  • 3,544 POSTS
U need to have the engine scoped to check the pattern for bad ing. Parts
Was this
answer
helpful?
Yes
No
Tuesday, March 20th, 2012 AT 10:54 PM

Please login or register to post a reply.

Sponsored links