2000 ford contour heater and temperature problems

160,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
DWAIN
  • MEMBER
  • 2 POSTS
my 2000 ford contour with a 2.5 liter engine will start blowing cold air and the temperature gauge will go all the way up to hot and then it blows hot air and the temperature gauge goes back to normal operating range. ive changed the thermostat and the etc sensor as well as the upper radiator hose. any ideas
Mar 23, 2011 at 2:00 PM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Sounds like you need to bleed the cooling system
Mar 23, 2011 at 2:07 PM
Avatar
WRENCHTECH
  • ✓Experienced Mechanic
  • 20,760 POSTS
You likely have a leak in the system and you need to pressure test the system to find and repair it. Bleeding the system will work temporarily but the problem will return when it gets low again and you are risking doing serious engine damage in the meantime.
Mar 23, 2011 at 2:26 PM
Avatar
DWAIN
  • MEMBER
  • 2 POSTS
thanx for replying. i check my coolant regularly and the coolant has always been at the rite level and there are no spots on the ground where i park my car. how would i go about bleeding the system? and how would that solve my issue. any ideas are welcome. ive been trying to fix this problem for 2 and a half months and i am very frustrated
Mar 23, 2011 at 4:36 PM
Avatar
WRENCHTECH
  • ✓Experienced Mechanic
  • 20,760 POSTS
The system can't get air into it without a leak. It can be evaporating before it hits the ground. You do need to pressure test to find out where it's going.
Mar 23, 2011 at 4:39 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle