2000 Ford Contour Fiance Started Car This Morning Sputtering Shut Off Wouldnt

2000 FORD CONTOUR
154,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
my fiance started her car this morning and was sputtering and then shut off. wouldnt start again so i hooked up code scanner to it and it read a code of cam position sensor so i replaced that part and now it still will not start. when it cranks over it is a pretty rough crank over im stuck on where else to go now.
Jan 28, 2013 at 11:21 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
codes never identify bad parts, just failed systems.

start with basics, compression, spark and fuel pressure.

my bet is possible timing belt failure

Roy
Jan 29, 2013 at 11:52 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.