2000 dodge stratus cv axcel

2000 DODGE STRATUS
182,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
CHRISRUSS
  • MEMBER
  • 1 POST
Need to change passenger cv axcel. Wqs wondering if there is anything I shoild be aware of that is not obvious. Will be replacing the axcel shaft seal are there any others seals or orings etc that I should be aware of?
Mar 28, 2011 at 11:58 AM
Advertisement
Avatar
WRENCHTECH
  • ✓Experienced Mechanic
  • 20,761 POSTS
You will probably need a large pry bar to "pop" the axle out of the trans. The new seal may not last long. It's usually caused by worn bearing and bushings in the trans causing too much axle movement.
Mar 28, 2011 at 12:16 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.