Dodge dash heater controls

88SCOTT

MEMBER
2000 DODGE DAKOTA
V8
4WD
AUTOMATIC
120,000 MILES

I need to replace the heater/AC/fan/climate control switch unit. How the heck do I remove the old one from the dash? And install the new unit?

Image (Click to make bigger)

Tuesday, May 10th, 2011 AT 8:09 PM

4 Replies

CARADIODOC

MECHANIC
33,873 POSTS

Did you look at the new one? You'll see that it snaps in. Pry it out on the bottom with a small flat blade screwdriver.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

+1

Tuesday, May 10th, 2011 AT 8:17 PM

88SCOTT

MEMBER
3 POSTS

I don't think it pops out. I got the new one here. And it looks like it mounts from behind the dash. Here is a photo of the new unit from the back. It looks like it has mounting holes on both the top and bottom.

Image (Click to make bigger)

Was this

answer

helpful?

Yes

No

+1

Tuesday, May 10th, 2011 AT 8:23 PM

88SCOTT

MEMBER
3 POSTS

Here is another angle photo of the unit.

Image (Click to make bigger)

Was this

answer

helpful?

Yes

No

+3

Tuesday, May 10th, 2011 AT 8:28 PM

CARADIODOC

MECHANIC
33,873 POSTS

You're right. The older ones I remember popped out very easily. Sorry about that. The closest service manual I have is for a 2001 Dakota and that shows a still different part but it mounts the same as yours. It specifies removing the instrument cluster bezel, (no mention of removing the entire cluster), then removing the dash panel to get to the screws behind the control panel. Normally most of that dash panel snaps into place but look around the bottom first for black philips-head screws. You'll have to move the shift lever down to get it out of the way.

Was this

answer

helpful?

Yes

No

Tuesday, May 10th, 2011 AT 8:37 PM