I want to know how to take apart a ignition for a 2000 Dodge Caravan

Tiny
FOOBARYOU
  • MEMBER
  • 2000 DODGE 600
  • 200,000 MILES
The key wont turn over the ignition so how do I take the ignition out
Monday, January 23rd, 2012 AT 6:53 PM

1 Reply

Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
STEERING COLUMN SWITCHES -2000 Dodge Caravan
Page 1 of 1
IGNITION SWITCH & LOCK CYLINDER

Tips Click a link to view tip
Question: IGN CYLINDER
Tech1
Removal

Tips Click a link to view tip
Question: LOCK CYLINDER
Tech1
1. Disconnect negative battery cable. Remove steering column cover retaining screws. Remove cable from parking brake release handle. Remove screws holding steering column shrouds. Remove
lower steering column shroud.
2. With ignition switch in RUN position, depress retaining tab. See Fig. 9. Remove lock cylinder. Using No. 10 Torx bit, remove ignition switch mounting screw. Depress retaining tab, and gently
pry switch from steering column. See Fig. 10. Disconnect electrical connectors.
Installation

To install, reverse removal procedure. Ensure ignition switch and actuator shaft in lock housing are in RUN position. Lock cylinder retaining tab will depress only in RUN position. Check for proper
operation of ignition switch in all positions. Check for proper operation of key-in warning switch.
Fig. 9: Removing Lock Cylinder
Courtesy of DAIMLERCHRYSLER CORPORATION
Fig. 10: Removing Ignition Switch
Courtesy of DAIMLERCHRYSLER CORPORATION
Fig. 11: Identifying Connector Locations Of Ignition Switch Courtesy of DAIMLERCHRYSLER CORPORATION
Was this
answer
helpful?
Yes
No
Monday, January 23rd, 2012 AT 8:48 PM

Please login or register to post a reply.

Sponsored links