2000 Chrysler Other Wont start

2000 CHRYSLER
160,000 MILES • 3.5L • V6 • FWD • AUTOMATIC
Avatar
CAVYMAN1
  • MEMBER
  • 3 POSTS
The car died on me while i was driving acouple years ago. Got it home and replaced the camshaft and crankshaft sensor because that was the most likely problem. Still nothing. Its getting fuel but no spark. Replaced spark plugs and still nothing. Could it be a bad ecu, probable cause with these cars.
Jan 30, 2014 at 6:51 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KNOWLEDGE IS POWER
  • EXPERT
  • 1,136 POSTS
the drivers for the plug coils and the injectors are in the ECM. you need to check outputs to the coils. the 12 volts that go to the plugs on each coil and also on each injector. a noid light is for this purpose and they are available and relatively inexpensive at parts stores. they just plug in to the coil or injector plug and will flash when the motor is rotated if all is well
Jan 30, 2014 at 7:24 AM
Avatar
CAVYMAN1
  • MEMBER
  • 3 POSTS
so i need to check the distributor and also check the injector plugs to make sure they are getting proper voltage to them. if the arent then should i start considering getting a new ecu???
Jan 30, 2014 at 11:09 AM
Avatar
CAVYMAN1
  • MEMBER
  • 3 POSTS
Also the car is a 2000 Chrysler 300m and they have a history of catastrophic ecu failure.
Jan 30, 2014 at 11:10 AM
Avatar
KNOWLEDGE IS POWER
  • EXPERT
  • 1,136 POSTS
you are correct the do have ecm problems. a lot of Chrysler products do. but still you should check for voltages at the coil packs and the injectors if youre sure you've got fuel. remember that the voltage will only pulse while cranking or running
Jan 30, 2014 at 1:06 PM