Car won't start with PRNDL fuse in

2000 CHRYSLER LHS
180,000 MILES
Avatar
MCASE
  • MEMBER
  • 1 POST
I have a 2000 Chrysler LHS. At first it wouldn't start and acted like it was in gear. I tapped on the outside of the console near the shifter and the car started, but the speedometer didn't work and the PRNDL indicator on the dash showed it was in all the gears at once. I checked the PRNDL fuse and noticed it was blown and changed it. Once again the car would not start (Acted like it was in gear). Here is where it gets funny. If I pull the PRNDL fuse out the car will start, but the speedometer and PRNDL dash indicator do not. If I start the car without a fuse and then put the fuse back in while it is running the speedometer and PRNDL dash indicator will work. If i shut if off it will not start again unless I pull the PRNDL fuse back out. What could be causing this? the Saftey Netural Switch?
Jul 18, 2012 at 9:51 PM
Advertisement
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Symptom indicates a fault with the Transmission Range Sensor Switch (PNP or Safety Neutral switch as you indicated) or its wiring.

Jul 19, 2012 at 1:41 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.