replacing rear disc brakes

2000 CHRYSLER GRAND VOYAGER
90,000 MILES • 2WD • MANUAL
Avatar
ARETIAN
  • MEMBER
  • 2 POSTS
changing rear disc brakes on 2000 chryster voyager cant get unit off hub undone 4 bolts on back but unit is still solid
Mar 14, 2011 at 6:32 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Are you trying to take the entire wheel bearing assembly off?
Mar 14, 2011 at 6:41 PM
Avatar
ARETIAN
  • MEMBER
  • 2 POSTS
no only trying to remove disc pads to put new ones in , had to undo two rear bolts to take off complete assembly to change front ones but rear has four bolts which i have removed but still unable to remove pads
Mar 15, 2011 at 8:27 AM
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
By "four bolts" do you mean two on each side or four on one wheel? The caliper is held on with just two small bolts inside rubber sleeves. Chrysler used to use 10 mm hex head bolts but I think they're using torx heads now, typically a T45 or possibly a T50.
Mar 15, 2011 at 7:14 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.