lately I've been having a hard time starting my truck?

2000 CHEVROLET TAHOE
22,300 MILES • 5.7L • V8 • 4WD • AUTOMATIC
Avatar
XYRENX
  • MEMBER
  • 1 POST
Hello lately I've been having a hard time starting my truck. It starts but takes a while of cranking. I've replaced the alternator, battery and starter and it still isn't always starting well. Just recently its been misfiring or running real rough after starting it when its warm. And after putting it into drive and moving a few feet it startsrunning better. When it runs rough I also smell quite a bit of fuel or oil. Any suggestions on where to start looking. I'm currently in auto tech school now.
Jan 12, 2015 at 6:37 PM
Advertisement
Avatar
HOMER1967
  • ASE Certified Mechanic
  • 875 POSTS
  • ASE Certified Mechanic
the very first thing you want to do is check the fuel pressure and volume.you could also try cycleing the key on and off a few times before you crank it and if that helps then you know that you have a fuel issue.
Jan 12, 2015 at 8:54 PM
Avatar
STRAILER
  • ASE Certified Mechanic
  • 54,837 POSTS
  • ASE Certified Mechanic
Good to hear, I agree with HOMER1967, it sounds like the fuel pump is weak which is super common on these cars. Here is a guide to help check the fuel pump to confirm the fuel pump failure.

https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

Key On Engine Off .................... 60-66 psi

If the fuel pressure is okay I would look at the fuel pressure regulator which can leak internally.

Check out the images (below). Please let us know what happens.
Dec 2, 2024 at 3:34 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.