How to change Secondary Air Injection Valve

Tiny
BDOG
  • MEMBER
  • 2000 CHEVROLET SUBURBAN
  • 150,000 MILES
Just need to know if anyone has a diagram or clear instructions on how to change Secondary Air Injection Valve. Thanks
Sunday, October 30th, 2011 AT 6:51 PM

7 Replies

Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
What motor? What codes did you read?
Was this
answer
helpful?
Yes
No
-1
Sunday, October 30th, 2011 AT 7:23 PM
Tiny
BDOG
  • MEMBER
  • 4 POSTS
P0410 was the code

5.3l V8 1500 Suburban 4wd
Was this
answer
helpful?
Yes
No
+1
Sunday, October 30th, 2011 AT 7:29 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Does ours look somethin like this?
Was this
answer
helpful?
Yes
No
-1
Sunday, October 30th, 2011 AT 7:35 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Remove the clamp from the check valve.
Disconnect the AIR hose from the check valve.

Before replacing a check valve, test the valve for proper operation.
Install a vacuum pump to the nipple side of the check valve, AIR pump side.

Pump the vacuum pump to 10 inches Hg and observe the gauge.

Replace the check valve if the vacuum bleeds down to zero within 5 seconds.

If defective, to replace, unscrew from airpipe and install new 1. Re attach hose and clamp. Done
Was this
answer
helpful?
Yes
No
+4
Sunday, October 30th, 2011 AT 8:12 PM
Tiny
BDOG
  • MEMBER
  • 4 POSTS
Yeah, haha I guess I should have looked under the hood before I posted, I can clearly see where they are, I just need to figure out which one is bad since I only bought 1.
Was this
answer
helpful?
Yes
No
Sunday, October 30th, 2011 AT 8:38 PM
Tiny
BDOG
  • MEMBER
  • 4 POSTS
Ok thanks
Was this
answer
helpful?
Yes
No
Sunday, October 30th, 2011 AT 8:40 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
Did you get this figured out BDog?
Was this
answer
helpful?
Yes
No
Thursday, December 1st, 2011 AT 7:28 PM

Please login or register to post a reply.

Sponsored links