drivers seat stuck

Check for power to the seat motor and the switch. Also, if there is power to the motor, chances are it is bad. If there is no power to the motor, then you need to work backwards checking the wiring to see where the power is lost.


Heres a guide on using a test light, its a great way to test for power

https://www.2carpros.com/articles/how-to-use-a-test-light-circuit-tester

The wiring diagram for your power seat is attached below, it show each motors function

power seat dosn't move at all;hear clicking from control box in rear of seat; seat was going up and down+ reclining but not forward or reverse, took seat out to look for obstruction, now only clicks.

Do you have a DVOM? some electrical knowledge?

yes, have digital meter; basic knowledge

Check for voltage at the motors while operating switch. voltage will be applied to one wire and ground on the other then switch when reversing motor via switch. Need to no if column or floor shift and heated seats?

Has both; floor shifter&heated seats

Is there a way to manually move the drivers side seat back when motor dies and seat is stuck in undesirable position? Is there a reset button or a latch that allows one to move it manually without the motor?

If you have voltage to the motors under the seat, the motors have got stuck due to excesive movement. this can occur when the motors uverrun due to switch being held on when the track has reached its end. Try to manually unwind the motor to release the tension and retry.

Unless the battery is weak if not you should be able to adjust the seat with ignition turned to RUN position.

The power seat switch is not working. How do you repair this?

swithces are replaced and need to be removed. check fuses and relay first though. it may not be getting power

Thank you for the reply to my question and so quickly.