whenever i apply the brakes it swerves

1999 TOYOTA 4RUNNER
261,000 MILES
Avatar
TAYODAISI
  • MEMBER
  • 8 POSTS
I usually feel there is a gap in my steering rotation with an end knocking feel. And whenever i apply the brakes it swerves in a way i have to try balance the wheels. What could have caused these and possible solutions pls
Jul 16, 2013 at 6:20 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
SQM
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 6,383 POSTS
Hello,

This pull during braking can be caused by seized brake caliper slides, failed brake hose, ball joint wear, loose inner tie rod end, it can also be due to tire core separation.

One of the common reasons is having seized caliper slides. When the caliper slide bolts get stuck or seized the caliper will either not fully engage or release creating a brake pull.
One way to check this is to drive the vehicle (safely) and after using the brake few times, stop and check the temperature of the rotors using an infrared laser temperature reader. If there is a problem, there will be a large temperature difference.


Here is a helpful guide that goes over the typical problems for brake pull:

https://www.2carpros.com/articles/car-pulls-right-or-left-when-driving-or-braking


Please let me know if you have any questions.
Thank you.
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Oct 24, 2021 at 8:43 PM
Advertisement