Coolant Level light is blinking

1999 SATURN SL2
63,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
LULUK
  • MEMBER
  • 3 POSTS
my 1999 Saturn sl2 coolant level light is blinking, I changed coolant reservoir and its cap with new one, I changed coolant temp sensor on the ingine with new one, Its start blinking after I found out the car horn is not working, may be is there any circuit shortage or any connection between horn electrical system with coolant level light?
Nov 24, 2010 at 3:08 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
I don't believe the two are related. There is a sensor in the reservoir. Did you replace that?
Nov 24, 2010 at 3:15 AM
Avatar
LULUK
  • MEMBER
  • 3 POSTS
Yes, I bought a Brand new reservoir and cap, Sensor is installed under the reservoir and they don't sell it seperately.before this problem when I clicking my remote door lock just twice I eas hearing beep from horn, original horn has three wire sockets and I bought a universal horn fro autozone with two wire sockets, now even i'm clicking twice the remote lock i can't hear the beep, because when i tried to connect third wire to any of two sockets tha horn was start nonstop beeping amd I disconnected the third wire, I tought matbe a circuit short that related to horn wires and coolant level light.
Nov 24, 2010 at 3:29 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
The two are on seperate circuits. Chances are there is a short from the coolant level switch wiring that is causing the light to come on and off. I hate to say it but you need to start tracing wires to check for damage.
Nov 24, 2010 at 2:19 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
That third wire to your horn is for your alarm when it goes off that make's it honk and when you push the lock button twice that third wire sends a signal to your horn to let you the alarm is armed.I would get the correct horn so all that work's correctly you could even find a used horn.As far as your low coolant light goes first thing to check before you start checking all your wire's is make sure your back up fuse is good if it is blown that will cause your low coolant light to stay on.If that is good then unplug your coolant bottle and jump the terminal's to your low coolant switch together and start the car and give it a couple of mins and see if the light is still on.If the light is still on after all that then start tracing the wire's.
Nov 24, 2010 at 8:08 PM
Avatar
LULUK
  • MEMBER
  • 3 POSTS
Thanks for your advise, which one is the backup fuse and where is it ?
Nov 24, 2010 at 8:36 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
It's in the under hood fuse box it's labeled B/U LP i posted a diagram so you can see where it's located.
Nov 24, 2010 at 8:51 PM