1999 Pontiac Trans Out Blue Car Will Into Gear Running Turned Off Seems Gear

1999 PONTIAC TRANS AM
15,100 MILES
Avatar
STEVEFED
  • MEMBER
  • 4 POSTS
Out of the blue, car will not go into any gear when car is running. Turned off, it seems to go into any gear. Is it clutch, solenoid, gear selector, master cylinder?????????????/ Note: 6 speed manual tranny.
Jan 19, 2013 at 11:38 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Most likely the MC. Make sure it is full of fluid.
Jan 20, 2013 at 2:20 AM
Avatar
STEVEFED
  • MEMBER
  • 4 POSTS
Thanks for input. I checked master cylinder level. It was just a tad low. ((Not low enough to suck air.) Is there a way to bleed this master cylinder like a brake system? If not, how much of a job is it to change out?
Jan 21, 2013 at 1:11 AM
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
It gets bled out at the slave cylinder.
Jan 21, 2013 at 4:02 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.