Where is the thermostat in a 1999
mazda b3000
mazda b3000
Dec 9, 2010 at 3:45 PM
fix it
1999 MAZDA B3000
SHABORN7
- MEMBER
- 1 POST
Advertisement
JACOBANDNICKOLAS
- ✓ASE Certified Mechanic
- 110,194 POSTS
This is what I was able to find for you.
Disconnect the negative battery cable.
Drain and recycle the engine coolant.
Remove the thermostat housing. (at the end of the upper radiator hose on the engine side)
Remove the three bolts and separate the water outlet adapter from the thermostat housing.
NOTE
The thermostat is indexed and must be installed correctly.
Remove the thermostat and the O-ring seal.
NOTE
Clean and inspect the sealing surfaces.
To install, reverse the removal procedure. Torque all fasteners to 89 inch lbs. (10 Nm).
Check for leaks.
Disconnect the negative battery cable.
Drain and recycle the engine coolant.
Remove the thermostat housing. (at the end of the upper radiator hose on the engine side)
Remove the three bolts and separate the water outlet adapter from the thermostat housing.
NOTE
The thermostat is indexed and must be installed correctly.
Remove the thermostat and the O-ring seal.
NOTE
Clean and inspect the sealing surfaces.
To install, reverse the removal procedure. Torque all fasteners to 89 inch lbs. (10 Nm).
Check for leaks.
Dec 9, 2010 at 4:38 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.