How To Replace Driver's side Rear Hub Bearing.

1999 HONDA ODYSSEY
120 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
MOLSONCANADIAN
  • MEMBER
  • 81 POSTS
Hi there, Is there any special tools needed to remove the rear hub bearing, such as a press?

Or is the only hard part removing the 36mm nut?
Thanks.
Image (Click to enlarge)
Attached Media
Mar 13, 2012 at 12:47 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
REAR SUSPENSION SYSTEM -1999 Honda Odyssey EX
Page 1 of 2
HUB & BEARING ASSEMBLY
NOTE:
Hub and bearing unit are replaced as an assembly.
Removal (Accord & Civic W/Drum Brake & Odyssey )
Loosen wheel lug nuts. Raise and support vehicle. Apply parking brake. Remove lug nuts and wheel assembly. Remove hub cap. Pry the spindle nut lock tab away from the spindle and remove spindle nut.
Release parking brake. Remove the brake drum, hub bearing unit and spindle washer.
Mar 13, 2012 at 12:53 AM
Advertisement
Avatar
MOLSONCANADIAN
  • MEMBER
  • 81 POSTS
Thank you
Mar 14, 2012 at 5:44 AM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
My pleasure. Be sure to tell your friends about us.
Mar 14, 2012 at 9:46 PM