1999 Honda Accord codes

FLYEYES

MEMBER
1999 HONDA ACCORD
6 CYL
2WD
AUTOMATIC
128,000 MILES

I have an error codes p0108, p0336, p113, p1519,1456. One is a crank shaft sensor. I recently had my mechanic replace timing belt and other belts and water pump. Everything was fine until 2 days later, outside was freezing (florida)I read online about crank shaft sensor and its doing that issue. We broke down car again to clean sensor. Everything worked fine, till this morning again, it was cold and I warmed up car. It is just not wanting to accelerate properly, act like it isnt getting enough air or gas on acceleration. Should I just go ahead and replace with new sensor? Or what else should I do? Please help

1 Reply

KHLOW2008

MECHANIC
41,814 POSTS

P0108 = MAP sensor circuit high voltage.

P0113 = IAT sensor circuit high voltage.

P0336 = CKP sensor intermittent interruption.

P1519 = IAC valve circuit malfunction.

P1456 = EVAP control system leakage (EVAP canister system)

Erase the codes and test drive vehicle to see if all the codes comes back or only some returns.

Check wireharness for proper and secure installation. I would not recommed replacing the components till you have confirmed the part is faulty.