i took my car to the dealer p0102 code

1999 FORD WINDSTAR

140 MILES

ANONYMOUS

MEMBER
1 POST

i took my car to the dealer p0102 code they said it was using so much gas because of upper and lower intake gaskets after over 800 dollars it did nothing what should i check and how

Mar 3, 2013 at 4:42 PM

KASEKENNY

✓ASE Certified Mechanic
18,907 POSTS

This code is telling you there is an issue with the mass air flow sensor.

However, this could just be a vacuum leak which is most likely what they found with the intake gaskets.

So, the way to test this to find what they did is to follow this guide:

https://www.2carpros.com/articles/how-to-use-an-engine-vacuum-gauge

However, this could be a MAF sensor issue itself so we will need to run through the voltage testing and check for shorts to find out if the voltage is the issue.

https://www.2carpros.com/articles/how-to-check-wiring

https://www.2carpros.com/articles/how-to-replace-a-mass-air-flow-sensor-maf

Please see the attached info below. If there are no vacuum leaks, then the most likely issue is the sensor. However, it could also be wiring or a PCM.

Please run through this info and let us know what you find with this, and we can go from there.

Thanks

Images (Click to enlarge)

Professional Diagram for 2CarPros Members
Click here to log in and view diagram.

Jan 8, 2022 at 8:45 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.