SPONSORED LINKS

Why dont I have drive after changing my transfer case

Tiny
SLUYGUY
  • MEMBER
  • 1999 FORD EXPLORER
I just changed the transfer case in my 99 ford explorer and naw there is no drive or it seems like the braks are on I can feel it go into drive and wen I press the gas it jolts forword but no power just revs up it go's into revers secend first no problum I dont no whut to do
SPONSORED LINKS
Tuesday, November 22nd, 2011 AT 6:09 PM

6 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Is the trans fluid clean and full?
Was this
answer
helpful?
Yes
No
Tuesday, November 22nd, 2011 AT 6:10 PM
Tiny
SLUYGUY
  • MEMBER
  • 4 POSTS
Yes new fluids in transfer case and new in trans with new filter
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, November 22nd, 2011 AT 6:14 PM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Check to make sure none of the cooling lines were pinched and check the linkage to the trans.
Was this
answer
helpful?
Yes
No
Tuesday, November 22nd, 2011 AT 6:21 PM
Tiny
SLUYGUY
  • MEMBER
  • 4 POSTS
Whell all lines are good and the linkage well it is a awd part time im wundering if I have to reset the speed sensers or somthing is a electronic transfer case just a bolt in an it shood work or do I have to set reset somthing to make drive work
Was this
answer
helpful?
Yes
No
Tuesday, November 22nd, 2011 AT 6:33 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Make sure the transfer case is not in neutral position. This will make the vehicle not move.

Roy
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Tuesday, November 22nd, 2011 AT 6:38 PM
Tiny
SLUYGUY
  • MEMBER
  • 4 POSTS
No not in neutrel revers secend and first and the auto 4x4 4lo switch works in all the gears but drive I even turned the o/d on and off no diffrence
Was this
answer
helpful?
Yes
No
Tuesday, November 22nd, 2011 AT 6:47 PM

Please login or register to post a reply.

Related Transfer Case Replace/Remove Content

VIEW MORE

Sponsored links