1999 Dodge Stratus power steering belt

1999 DODGE STRATUS
180,000 MILES • 2.5L • V6 • AUTOMATIC
Avatar
RSHAVERS
  • MEMBER
  • 7 POSTS
I put a smaller serpentine belt on the car to bypass the ac compressor because it is no longer functional. I was able to get the car running but now I notice my power steering is not working and there is a whining noise coming from where the belts are located on the vehicle. I had to loosen the power steering belt to access the serpentine belt and I'm wondering if the power steering belt is either too loose or tight?
Jun 2, 2015 at 11:55 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
it may be either or it's low on fluid have it checked with a belt tension gauge.
Jun 3, 2015 at 2:49 AM
Avatar
RSHAVERS
  • MEMBER
  • 7 POSTS
I noticed that I have some side to side motion in the power steering pulley and it does not seem properly aligned....I think this may be my issue. How do I tighten the loose power steering pulley?
Jun 4, 2015 at 1:04 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
you need a special tool to do that but it may be end play in pump is what you are seeing. the pulley may be on all the way. take a straight edge and check from pulleys to see if it is aligned or not. auto parts may have the tool to rent but I you tighten it don't put all your hopes in that. you have modified from original design so that may be part of it as well.
Jun 4, 2015 at 2:25 AM
Avatar
RSHAVERS
  • MEMBER
  • 7 POSTS
I used a straightedge and the pulleys are not properly aligned. The car is drivable right now but is hard to steer and I had a new power steering pump installed around February.
Jun 4, 2015 at 4:26 AM
Avatar
RSHAVERS
  • MEMBER
  • 7 POSTS
There is a sound coming from the pulleys also.
Jun 4, 2015 at 4:27 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
then rent the tool from auto parts and see I fpulley will go on farther. the sound may be from the p/s pump alignment. because you are by passing the a/c you may have to put up with the sound due to eliminating the a/c or it may not be the correct belt either.
Jun 4, 2015 at 5:28 AM
Avatar
RSHAVERS
  • MEMBER
  • 7 POSTS
Ok thanks for all the help Sir
Jun 4, 2015 at 5:57 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.