SPONSORED LINKS

Truck was running well, filled the tank, drove.

Tiny
CJMACK
  • MEMBER
  • 1999 DODGE RAM
  • 155,000 MILES
Truck was running well, filled the tank, drove home parked with nose up hill, will not restart, no spark at coil, replaced coil, nothing, replaced cam position sensor and crank position sensor, nothing, replaced pcm, still cranks and no start, traced all wiring from key out, nothing, repluged all 3 sensors replaced and it started, would not go above idle, attaced fuel pressure gauge no start again, replaced fuel pump, nothing, it now has pressure and does not bleed down, 1999 dodge ram 1500, 5.2
SPONSORED LINKS
Sunday, February 24th, 2013 AT 5:20 PM

4 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Did you put the old pcm back? It most likely was not the issue. Was it new? Was it re flashed?

Roy
Was this
answer
helpful?
Yes
No
Sunday, February 24th, 2013 AT 5:27 PM
Tiny
CJMACK
  • MEMBER
  • 3 POSTS
Was new, replaced with old one
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Sunday, February 24th, 2013 AT 5:29 PM
Tiny
CJMACK
  • MEMBER
  • 3 POSTS
Just updating. Replaced the TPS, ran good at idle and good over 2000 RPM. Drove around the block, shut it off and it will not restart.
Was this
answer
helpful?
Yes
No
Saturday, March 2nd, 2013 AT 1:28 AM
Tiny
CJMACK
  • MEMBER
  • 3 POSTS
The truck ran better with the old pcm so I pulled out the new and replaced with the old. It has not been re flashed.
Was this
answer
helpful?
Yes
No
Saturday, March 2nd, 2013 AT 1:34 AM

Please login or register to post a reply.

Related Camshaft Camshaft Sensor Replace/Remove Content

Camshaft Position Sensor Replacement
GUIDE
Camshaft Position Sensor Replacement
Replacing an engine camshaft position sensor is a critical maintenance task that can restore your vehicle's performance and fuel efficiency. A faulty camshaft sensor can...
VIEW MORE

Sponsored links