Where is the signal flasher relay located?

REMOVAL

Disconnect and isolate the battery negative cable.
Remove the fuse access panel by unsnapping it from the driver side end of the instrument panel.
Remove the combination flasher from the junction block.

INSTALLATION

Position the combination flasher in the proper receptacle in the junction block.
Align the combination flasher terminals with the terminal cavities in the junction block receptacle.
Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the junction block receptacle.
Install the fuse access panel by snapping it into the driver side end of the instrument panel.
Reconnect the battery negative cable. The location of the combination flasher is in the diagrams below.