How do you change the driver side low beam bulb on a 1999 Dodge Intrepid?
Apr 8, 2011 at 6:52 PM
Changing headlight blubs
1999 DODGE INTREPID
LINDA KAUFFMAN
- MEMBER
- 1 POST
Advertisement
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
Release hood latch and open hood.
Remove jackscrews attaching headlamp housing to crossmember and remove the lamp housing to access the lamps).
Headlamp Bulb
Disconnect wire connector from back of lamp socket.
Rotate bulb (High beam or Low beam) and pull from headlamp housing.
INSTALLATION
CAUTION : Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.
Place into headlamp housing and rotate to the lock position.
Connect wire connector to bulb.
Place lamp housing in position on vehicle.
Verify headlamp operation.
Install jackscrews to attach headlamp housing to crossmember.
Verify headlamp operation and alignment.
Remove jackscrews attaching headlamp housing to crossmember and remove the lamp housing to access the lamps).
Headlamp Bulb
Disconnect wire connector from back of lamp socket.
Rotate bulb (High beam or Low beam) and pull from headlamp housing.
INSTALLATION
CAUTION : Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.
Place into headlamp housing and rotate to the lock position.
Connect wire connector to bulb.
Place lamp housing in position on vehicle.
Verify headlamp operation.
Install jackscrews to attach headlamp housing to crossmember.
Verify headlamp operation and alignment.
Apr 8, 2011 at 7:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.