99 Dodge Intrepid

1999 DODGE INTREPID
6 CYL
Avatar
KPADGETT
  • MEMBER
  • 1 POST
The engine cranks, but won't turn over. Ihave fuel pressure but no spark to any of the plugs. I suspect the camshaft/crankshaft sensors, but not sure if the coil pack could be the culprit. How do I check it?
Feb 12, 2011 at 6:41 PM
Advertisement
Avatar
CARADIODOC
  • ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
"Crank" and "turn over" are the same thing. I'm assuming you mean it's cranking since you're checking for spark. The best thing to do is measure the voltage on the dark green / orange wire to the coil pack or any of the injectors. You should find battery voltage for one second after the ignition switch is turned on, then it should come back during engine cranking. If it doesn't come back during cranking, the cam and crank sensors are definite possibilities. The cam sensor is the more common one but if the Check Engine light is on there may be a diagnostic fault code that will point the problem circuit.

caradiodoc
Feb 13, 2011 at 1:22 AM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
what was it? thanks
Jun 14, 2011 at 4:50 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.