1999 Dodge Grand caravan charging system fluxuation

1999 DODGE CARAVAN
6 CYL • 2WD
Avatar
DAVIDBURDICK4
  • MEMBER
  • 3 POSTS
My battery light comes and goes, the battery is not getting properly charged. It is losing power. I had the system tested 5 times. I cleaned the connectors and terminals and replaced the battery. I had the Alternator checked, all this is good. Yet i still get a power drop and my battery is getting drained? Any ideas??
Jan 13, 2011 at 5:03 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
PCM controls field circuit as to output so PCM maybe faulty. Check engine light on? has PCM been checked for codes?
Jan 13, 2011 at 5:12 PM
Advertisement
Avatar
DAVIDBURDICK4
  • MEMBER
  • 3 POSTS
no they only tested the system. the check engine light is not on. only the battery light.
Jan 13, 2011 at 5:36 PM
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
Common too for brushes to be worn and intermittent. On many Chrysler products they can be replaced without removing the alternator from the engine. Any testing has to be done while the problem is occurring. No problem will be found when the system is working because no problem exists at that time.

(Hi Docfixit)
caradiodoc
Jan 13, 2011 at 5:44 PM
Avatar
DAVIDBURDICK4
  • MEMBER
  • 3 POSTS
ok on that model, is there more than one PCM? and where is it located? Also which one is responsible for the alternator?
Jan 13, 2011 at 5:59 PM
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
Engine computer is the Powertrain Control Module. It has the voltage regulator built in.

When the problem acts up, measure the voltages on the two small terminals on the back of the alternator. They could be two plugged-in wires or two small nuts next to a black plastic block. One of those will have full battery voltage when the engine is running. The secret to diagnosing this system is the voltage on the other nut. If it is 0 volts, the brushes are open. If it is the same as the first terminal, the voltage regulator in the PM could be bad but more likely the wire going to it is open. If that part of the system is working the voltage will be less than the first terminal.

caradiodoc
Jan 13, 2011 at 7:02 PM