Advertisement

1999 Chrysler Sebring starting

142,000 MILES
Avatar
COLEMAN74
  • MEMBER
  • 21 POSTS
Car,will turn,over but wont start.after holding ignition on for 5 seconds it starts but dies the rpms didn't go past 500. Could anyone help................................ It takes a long time to turn over..
Jun 15, 2013 at 9:17 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
Start by checking fuel pump pressure. Or, see if the car will start with starting fluid. If it does, you have a fuel system problem.

Sounds like the battery might have been disconnected or run dead recently. If so, the Engine Computer lost its memory and has to relearn "minimum throttle" before it will know when it must be in control of idle speed. It also might not give you the normal "idle flare-up" to 1500 rpm when you start the engine. In fact, it is usually necessary to hold the gas pedal down 1/4" to get the engine to start and stay running. To meet the conditions for the relearn to take place, drive at highway speed with the engine warmed up, then coast for at least seven seconds without touching the brake or gas pedals.

have battery checked for condition and load test. scan for codes
Jun 15, 2013 at 11:56 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle