1999 Chrysler LHS Valve body

1999 CHRYSLER LHS
138,000 MILES
Avatar
SAVYGUY
  • MEMBER
  • 4 POSTS
I had to replace the transmission range senor on the valve body, no problem there. When it comes to reassembly I am having some difficulty. On top of the valve body there is a bar about the same diameter as a pencil with a spring on it and a roller on the end of it. Where does this go or rather how is it supposed to be placed?
Aug 15, 2013 at 3:00 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
see pic
Image (Click to enlarge)
Attached Media
Aug 16, 2013 at 6:33 AM
Avatar
SAVYGUY
  • MEMBER
  • 4 POSTS
The piece I am concerned about isn't shown in that picture. It's attached to the part labeled "2" in the pic, on the left hand side as you're looking at the pic.
Aug 16, 2013 at 6:54 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
this is all we have unless you are talking about item 12 which is the sensor itself. th e roller shold ride against item 2 at the bottom in the notches. so it will know where to put valve.
Images (Click to enlarge)
Attached Media
Attached Media
Aug 16, 2013 at 7:00 AM
Avatar
SAVYGUY
  • MEMBER
  • 4 POSTS
I found a pic online, the piece is just to the right of the range sensor, pointing to the right.
Image (Click to enlarge)
Attached Media
Aug 16, 2013 at 7:31 AM
Avatar
SAVYGUY
  • MEMBER
  • 4 POSTS
I believe it's the parking pawl, just don't know how it is supposed to be situated'
Aug 16, 2013 at 10:00 AM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
this is the only pic we have of the parking sprag and that will connect to it. if it's for that. taek pictures next time if you don't know how ti goes back together.
Image (Click to enlarge)
Attached Media
Aug 16, 2013 at 10:10 AM