grand voyager 3.3 (99)

1999 CHRYSLER GRAND VOYAGER
6 CYL • FWD • AUTOMATIC
Avatar
GRAHAM20873
  • MEMBER
  • 1 POST
i have just rebuilt top end of engine on chrysler grand voyager 3.3 on 99 plate, both sets of cylinders, done water pump, radiator coolin system,engine runs fine, but when in gear has power at low end but when it reaches 3000 revs starts to misfire and loose power, any help would be much appreciated many thanks graham
May 4, 2011 at 7:01 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
--Engine running rough or misfiring can be cause by the following:

https://www.2carpros.com/articles/engine-misfires-or-runs-rough

1.Defective spark plugs
2.Inadequate spark/coil,defective spark plug wire.
3.Lack of compression
4.False air leakage.
5.Faulty fuel injectors.
6.Insufficient fuel pressure.
7.Contaminated fuel.
8.EGR valve that is leaking.
9.Oxygen sensors.
10.Throttle position sensor.
11.Manifold absolute pressure sensor
12.Mass Airflow Sensor
13.Idle air control valve

Note: If it doesn't apply disregard it-
May 4, 2011 at 7:07 PM
Advertisement