no spark

1999 CHRYSLER CIRRUS
147,000 MILES • 6 CYL • FWD
Avatar
PARKER MCDANIEL
  • MEMBER
  • 5 POSTS
we have a 1999 chrysler cerrus and we have no spark, we have changed the control module in the distributor, what elase could it be? we have poweer from the asd relay on start mode. still no spark.... scan tool has no codes.
Jan 9, 2011 at 12:36 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
I'm not sure what you have going here. First, there is no 3.5 engine for that car. Second, there is no control module in the distributor so you need to clarify what your working on and what you changed.
Jan 9, 2011 at 12:59 AM
Advertisement
Avatar
PARKER MCDANIEL
  • MEMBER
  • 5 POSTS
i'm sorry it is a 2.5, it was a slip of the keys. and the part of the distributor that the the two wire harnesses hook to. that is what we replaced. any suggestions?
Jan 9, 2011 at 1:37 AM
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
You need to test for injector pulse using a noid light. If you find no injector pulse either, then look at the crank sensor
Jan 9, 2011 at 1:40 AM
Avatar
PARKER MCDANIEL
  • MEMBER
  • 5 POSTS
is the crank sensor in the distributor on this model?
Jan 9, 2011 at 1:45 AM
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
No, it's near the distributor but reads off the flywheel. https://www.2carpros.com/images/external/78286640.gif
Jan 9, 2011 at 1:49 AM
Avatar
PARKER MCDANIEL
  • MEMBER
  • 5 POSTS
thank you so much, i will look at that first thing in the morning.
Jan 9, 2011 at 1:55 AM