where are the spark plugs on a 1999 chrysler 300M

107,000 MILES
Avatar
RYANCATHY
  • MEMBER
  • 4 POSTS
I have a 1999 chrysler 300m and dont know where the spark plugs are If you can help that would be great
Aug 25, 2012 at 12:49 PM
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Always remove the spark plug boot by grasping at the spark plug boot, turning the boot 1/2 turn and pulling straight back in a steady motion.

REMOVAL

Prior to removing the spark plug, spray compressed air around the coil area and spark plug.
Remove electrical connector from ignition coil.

It is necessary to loosen the screws by alternating back and forth. Do not lose the spacers under the coil when loosening the screws.

Remove 2 fasteners from ignition coil.
Remove ignition coil.
Remove rubber boot from spark plug.
Remove the spark plug using a quality socket with a rubber or foam insert.
Inspect the spark plug condition. Refer to Spark Plug Condition.

INSTALLATION

To avoid cross threading, start the spark plug into the cylinder head by hand.
Tighten spark plugs to 28 N.m (20 ft. lbs.) torque.
Install rubber boot onto ignition coil.
Install ignition coil and boot onto spark plug.
Install coil screws and tighten to 6.7 N.m (60 in. lbs.) .
Connect the electrical connector.
Aug 25, 2012 at 1:02 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle