how change cam sensor on a a 1999 chevy venture
Feb 17, 2011 at 1:44 PM
change cam sensor
1999 CHEVROLET VENTURE
TARRANCE1
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
NOTE: The Camshaft Position Sensor graphic illustrates the original factory installation. Do not route the new sensor pigtail as shown. Follow the Installation procedure below. Handle carefully in order to avoid damage to the sensor and pigtail. Route away from electronic components in order to avoid Electromagnetic Interference (EMI) .
REMOVAL PROCEDURE
Disconnect the negative battery cable.
Remove the serpentine drive belt.
Remove the power steering pump assembly.
Remove the electrical connector.
Remove the bolt.
Remove the sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
Install the Camshaft Position Sensor.
Tighten
Tighten the retaining bolt to 10 N.m (8 lb ft) .
Connect the electrical connector.
Install the power steering pump.
Install the serpentine drive belt.
Connect the negative battery cable.
REMOVAL PROCEDURE
Disconnect the negative battery cable.
Remove the serpentine drive belt.
Remove the power steering pump assembly.
Remove the electrical connector.
Remove the bolt.
Remove the sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
Install the Camshaft Position Sensor.
Tighten
Tighten the retaining bolt to 10 N.m (8 lb ft) .
Connect the electrical connector.
Install the power steering pump.
Install the serpentine drive belt.
Connect the negative battery cable.
Image (Click to enlarge)
Mar 13, 2011 at 11:57 PM
Advertisement