Installing Mirrors with blinkers

1999 CHEVROLET SILVERADO
18,100 MILES
Avatar
WILBUR700
  • MEMBER
  • 1 POST
Would like to install mirrors with the blinkers in them but am not sure how to run the electrical wires through the door and where to hook them into.
Mar 25, 2012 at 1:49 PM
Advertisement
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Between the door and pillar there is a wireharness that is for wires bewteen body and door. that is where you should be running them.

Wires should be hooked to the turn signal wires going to either front or rear turn signal bulbs. Additional bulbs might affect the turn signal blinking rate and you might need to replace the relay with one of the correct rating.
Mar 25, 2012 at 5:55 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.