idler tensioner pully asembly

1999 CHEVROLET CAVALIER
120,000 MILES
Avatar
BARRYSHEAN
  • MEMBER
  • 1 POST
99 cav 2.2 engine bolt going through idler tensioner asembly about 3 inches long only have 1 inch clearance to back it out have tried jacking car but still not enough clearance whats up
Sep 10, 2011 at 2:58 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Is it hitting the frame? Are you able to twist it in a direction that will allow it to come out? I've always been able to get them out with persuation. make sure the tensionier isn't already loose and moveable with the bolt in place.
Sep 10, 2011 at 3:02 AM
Avatar
SATURNTECH9
  • ✓ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
Put a floor jack under the engine oil pan with a block of wood between the jack and oil pan support the engine with the jack.Remove the upper mount and jack the engine up that should give you the clearance you need.
Sep 10, 2011 at 3:03 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.