Stalling when putting shifter into gear

Tiny
MATTCHEVYGUY333
  • MEMBER
  • 1999 CHEVROLET BLAZER
  • 157 MILES
I have a 99 s10 blazer and when I put it in gear is stalls like something is locking up because it is not working, I replaced the throttle position sensor and when it stalls it shakes really bad in reverse like something is locking up. When I replaced the two sensors it didn't do it in drive just a little bit in reverse then 2 days later it does it in both drive and reverse

Please help
Sunday, September 18th, 2011 AT 4:56 AM

4 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Have any warning lights come on? Does the vehicle jump when this happens or just turn off? What sensors did you replace?
Was this
answer
helpful?
Yes
No
-2
Sunday, September 18th, 2011 AT 4:59 AM
Tiny
MATTCHEVYGUY333
  • MEMBER
  • 4 POSTS
It stalls but when it stalls it****** like it locking up. And the sensors I replaced are the throttle position sensor and the idle air control. After I replaced them it stopped for 2 days and now does it every time I put it in gear
Was this
answer
helpful?
Yes
No
Monday, September 19th, 2011 AT 3:19 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
If the car jumps, it sounds like it may be transmission related.
Was this
answer
helpful?
Yes
No
-1
Monday, September 19th, 2011 AT 3:29 AM
Tiny
MATTCHEVYGUY333
  • MEMBER
  • 4 POSTS
I think it started after I put in a used rear end
but it stoped after I replaced sensors but did it 2 days later
Was this
answer
helpful?
Yes
No
-2
Monday, September 19th, 2011 AT 5:03 AM

Please login or register to post a reply.

Sponsored links